Spline = Hitec 24T Spline
Width = 1/4” (.250”)
Pressure Angle = 20°
Finally a way to drive gears using servos! Our patented 48 pitch Hitec metal gears are designed to attach directly to the output spline of a servo. All gears are broached directly into the metal to ensure a snug fit that will not slip. These gears are designed to fit the standard 24 tooth Hitec output spline. Patented.
15 tooth gear attached to an HS-645MG.
20 tooth gear attached to an HS-645MG.
36 tooth gear attached to HSR-1425CR.
Mated to a 120T Spur Gear.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Loading
Copyright 1999-2011 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.