By attaching a clamping or set-screw hub, you can attach the tilt directly to a shaft.
Our new DDT500 System is perfect for cameras or sensors up to 2 lbs. One of the biggest problems with servos is they can not always handle heavy side loads even though they may have the power to rotate your attachment. As you can see from the pictures, our system utilizes the servo output shaft and a ball bearing on the opposite end. This configuration along with rigid 1/4” ABS plastic makes it one of the most rigid and precise tilts available. The bottom plate has our hub configuration so that you can use any of our clamping or set-screw hubs with the DDT500. The top mounting plate has three 1/4” holes but can be easily drilled to accept other attachments. The DDT500 Tilt uses any standard size Hitec or Futaba servo. For cameras up to 1 lb, the HS-645MG or the HS-475HB servos work very well. For cameras up to 2 lbs, we suggest the HS-985MG. Unit comes unassembled with full instructions. If you have any questions please call or email tech@servocity.com. Servo not included with kit.
DDT500 is mounted to the SPG785 pan system.
DDT500 mounted to the DDP125 pan system.
Click here to watch a video of our DDT500 Tilt System in action!
(Hub not included)
This kit weighs 3.25oz without servos.
This product utilizes a
0.770” hub pattern.
Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Proud Distributor of
