E/Z connectors allow you to use pushrods without bending them at all. Simply install the E/Z Connector on the servo arm, slide the pushrod through it, and tighten the screw.

Standard E/Z Connector with re-usable nylon snap-on or permanent mount push-nut.

Heavy Duty E/Z Connector with re-usable nylon snap-on or permanent mount push-nut.

Heavy Duty 4-40 E/Z Connector with steel push nuts.

BULK PACK - Standard E/Z Connectors with re-usable nylon snap-on or permanent mount push-nut.

BULK PACK - Mini E/Z Connectors (ideal for Park Flyers).

Mini E/Z Connector (ideal for Park Flyers).

- Works with 2-56 and smaller wire
- Permanent or snap on mounting push nuts are both inlcuded

Includes:
- 2 brass E/Z Connectors
- 2 plastic snap nuts
- 2 metal snap nuts
- 2 4-40 x 1/8” slotted head screws
 

- Works with 2-56 and smaller wire
- Permanent or snap on mounting push nuts are both inlcuded

Includes:
- 2 aluminum E/Z Connectors
- 2 plastic snap nuts
- 2 metal snap nuts
- 2 4-40 x 3/16” cap head screws

- Works with 4-40 push rod wire

Includes:
- 2 steel E/Z Connectors
- 2 steel retaining washers
- 2 4-40 x 3/16” cap head screws
 

- Lightweight aluminum design (0.25g) allows for up to .047 wire.

Includes:
- 2 aluminum E/Z Connectors
- 2 plastic snap nuts
- 2 2-56 slotted head screws
 

- Brass connector is round with
pre-drilled center hole
- Black nylon retainers

Includes:
- 12 brass E/Z Connectors
- 12 plastic snap nuts
- 12 metal washers
- 12 socket head cap screws

- Lightweight aluminum design (0.25g) allows for up to .047 wire.

Includes:
- 12 aluminum E/Z Connectors
- 12 plastic snap nuts
- 12 2-56 slotted head screws

Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.

Newsletter Sign-up

Proud Distributor of