Switch two relays on and off with an R/C system or servo controller! Normally open and normally closed solder points are provided for each relay. You can drive two independent motors, contactors or pneumatic/hydraulic solenoids. Plus a simple wiring configuration also converts this to a mechanical H-bridge which is perfect for running a single linear actuator or motor in both forward/off/reverse. When used with one of our actuators, optional inputs from limit switches permit you to arrest motion in either direction. The silver cadmium oxide relay contacts offer you a maximum motor/coil load of 12 amps at 30 VDC (inductive). Fault detection safely switches off both relays if receiver signal is lost. Complete instruction manual is included.
Switch Controllers
Click on the picture for further information.
Supply Voltage: 3.8-5.5 VDC
Supply Current: 20ma static, 75ma energized
Load Rating: 0-30 VDC at 12.0A
Switching Time: 7.0 milliseconds
Switch Resistance: .012 ohms
Dimensions: 1.85”x2.70”x1.10”
Weight: 1.4oz
Detailed Specifications
Note: Male servo lead not included.
8-Servo Controller
Servo Joystick
Manual Servo Driver
Servo Recorder
R/C Controller
Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Proud Distributor of
