Electronic PWM Controlled Relay (24amp)

Take the advanced control firmware of the RCE200H solid state D-switch and mate it with a heavy-duty relay and this is what you get! Switch up to 24 amps on and off with one receiver channel or servo controller channel. Four threshold positions.
Minimal soldering required - make those high current connections with 0.250" female quick disconnects right on the relay. 12ga wire crimps are included.
Fault detection safely switches off the relay if receiver or controller signal is lost. But do note that since it's mechanical, it won't protect you from welded relay contacts. Complete instruction manual is included.

(Includes .250” Female Quick Connectors)

Switch Controllers

Click on the picture for further information.

Supply Voltage: 4.1-5.5 VDC
Supply Current: 20ma static, 220ma energized
Load Rating: 0-30 VDC at 24.0A
Switching Time: 8.0 milliseconds
Switch Resistance: .012 ohms
Dimensions: 1.75”x2.50”x1.25”
Weight: 2oz

Detailed Specifications

Note: Male servo lead not included.

8-Servo Controller

Servo Joystick

Manual Servo Driver

Servo Recorder

R/C Controller