(1) Servo Plate
(1) Ball Bearing Plate
(1) Plain Servo Shaft
(2) Hub Plates
(12) 6-32 Screws
Weight (no servo): 1.3 oz
Plain Servo Shaft
We are proud to introduce our new patented ServoBlocks! ServoBlocks increase a servo’s load-bearing capabilities by helping to isolate the lateral load from the servo spline and case. The extreme versatility of ServoBlocks allow users to create complex, extremely rigid, structures with ease using standard Futaba servos. Using a clamping hub (not included) on the ½” aluminum servo shaft provides an easy way to adjust the position of the component attached to the ServoBlock. The robust 6061 T-6 aluminum framework acts as a servo exoskeleton, greatly enhancing the mechanical loads the servo can withstand. Our new .770” hub pattern is repeated throughout the framework to allow endless attachment options. Compatible with all standard size Futaba servos. Kit comes unassembled, servo not included. Patented.
Ball-bearing supported output shaft.
Futaba ServoBlocks Kit
Using a 0.770” clamping hub (not included) on the ½” aluminum servo shaft provides an easy way to adjust the position of the component attached to the ServoBlock.
Think this is cool?
Share with your friends!
ServoBlocksTM utilize a
0.770” hub pattern.
ServoBlocksTM work in conjunction with our new aluminum channel.
This product (#637116) was previously SB609SF.
Copyright 1999-2014 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
Proud Distributor of