Our new gear racks are made from durable Delrin. We offer them in both 48 and 32 pitch (20° pressure angle) configurations that are 12” long and 1/8” wide. They work perfectly with any of our metal brackets. The racks can also be bent to form around curves.
48 Pitch Gear Rack (183 teeth)
32 Pitch Gear Rack (122 teeth)
The schematic below has been magnified for easier reading.
Height: 0.391” (base to top of teeth)
Height: 0.4185” (base to top of teeth)
NOTE: The hole spacing is 2” on center for the inner holes (see above); and 1.75” on center for the outer most holes (see below).
Copyright 1999-2014 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
Proud Distributor of