HPP-21 Servo Programmer


	ServoCity- Electronics & Accessories- Servo Programmer/Tester- HPP-21 Servo Programmer-


	HPP-21 Servo Programmer


	The all new HPP-21 will allow you to easily check any servo brand’s servo performance by using servo test functions and set most for the programmable parameters of Hitec digital servo types as noted below. This unit is a must have for those using Hitec digital servos in various applications.


	Functions: Fail Safe on/off Direction of rotation Resolution Setup (G2 Hitec Servos Only) Travel Speed Center, End and Fail Safe Point Dead Band Width OLP Rate (Overload Protection Rate, G2 Hitec Servos) “Save and Open” File Options Reset Servo to Factory Default Program

Price:

$26.99

Part:

44440

Status:

Qty:


	Download Software (here)

The HPP-21 will program the following features of these Hitec digital servos:
- All HS-7XXX G2 servos: Fully programmable, including OLP Rate and high
resolution adjustments.
- Some HS-5XXX types servos: Fully programmable Feather and Micro Digital servos
including OLP Rate; excluding high resolution adjustment function (HS-5055, 5056, 5082, 5085)
- Other HS-5XXX type servos: All features are programmable except OLP Rate and high resolution
adjustment functions.


	The HPP-21 does not come from Hitec with an interface cable. To the left is the correct cable that is needed. If you have your own cable, make sure that it is 3 feet or less in length.


	HPP-21 Interface Cable

Price:

$7.99

Part:

4444-IC

Status:

Qty:


	Be sure to check out our new Servo Protractor (angle tester). Works perfect for setting up multiple digital servos to the same angle.


	Copyright 1999-2010 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.