Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.17sec/60° at no load
Operating Speed (6.0V): 0.13sec/60° at no load
Stall Torque (4.8V): 41.66 oz/in. (3kg.cm)
Stall Torque (6.0V): 48.6 oz/in. (3.5kg.cm)
Operating Angle: 40 Deg. one side pulse traveling 400usec
360 Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 7.4mA/idle and 180mA no load operating
Current Drain (6.0V): 7.7mA/idle and 230mA no load operating
Dead Band Width: 5usec
Motor Type: 3 Pole Ferrite Motor
Potentiometer Drive: Direct Drive
Bearing Type: Dual Ball Bearing
Gear Type: 4 Metal Gears, 1 Metal Resin Gear
Connector Wire Length: 11.81" (300mm)
Dimensions: 1.18" x 0.39"x 1.33" (30 x 10 x 34mm)
Weight: 0.84oz (24g)
Detailed Specifications
The HS-125MG is an absolutely amazing servo. At only .39” thick it is perfect for ultra thin wings or specialized robot applications. Dual ball bearings and metal gears ensure great durability. You do need to know that the spline is different than standard Hitec servos. It is smaller so standard horns from other Hitec servos will not fit. Be sure to check out our manufactured horns that will work with the HS-125MG and the HS-5125MG.
|
|
49 oz-in. |
|
0.13 sec/60° |
This servo can only operate 90° due to the design of the internal gears. Over-driving may cause damage.
Uses B1 Mini Spline
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Copyright 1999-2011 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.