HS-225MG Mighty Mini


	ServoCity- Servos & Accessories- Hitec Servos- HS-225MG Mighty Mini-


	HS-225MG Mighty Mini

67 oz-in.

0.11 sec/60°


	All the great aspects of the HS-225BB are enhanced with the HS-225MG by switching to metal gears. Although metal gears wear faster than nylon, they offer a tremendous strength advantage. Metal gears also enable the HS-225MG servo to be modified for continuous rotation for wheeled applications. Packing a lot of power in a small servo is what the HS-225MG servo is all about.




	Detailed Specifications
	Control System: +Pulse Width Control 1500usec Neutral Required Pulse: 3-5 Volt Peak to Peak Square Wave Operating Voltage: 4.8-6.0 Volts Operating Temperature Range: -20 to +60 Degree C Operating Speed (4.8V): 0.14sec/60° at no load Operating Speed (6.0V): 0.11sec/60° at no load Stall Torque (4.8V): 54.15 oz/in. (3.9kg.cm) Stall Torque (6.0V): 66.65 oz/in. (4.8kg.cm) Operating Angle: 45 Deg. one side pulse traveling 400usec 360 Modifiable: Yes Direction: Clockwise/Pulse Traveling 1500 to 1900usec Current Drain (4.8V): 8mA/idle and 300mA no load operating Current Drain (6.0V): 8.8mA/idle and 340mA no load operating Dead Band Width: 8usec Motor Type: 3 Pole Ferrite Potentiometer Drive: Indirect Drive Bearing Type: 1 Ball Bearing and 1 Oilite Bushing Gear Type: 4 metal and 1 nylon Connector Wire Length: 11.81" (300mm) Dimensions: See Schematic Weight: 0.99oz (27g)




	This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to use our servo stretcher for 180° operation.

Price:

$27.99

Part:

32225S

Status:

Rotation:

Direction:

Qty:

General Servo Information

What is a Servo

How Servos Work

What Servo to use

Servo Power & Speed

Rotation Direction

Connector Types

180° Rotation

Continuous Rotation

Modifying Servos


	A = .660” (16.77mm) B = .470” (11.95mm) C = 1.06” (26.94mm) D = .310” (7.87mm) E = .328” (8.35mm) F = .942” (23.94mm) G = .380” (9.66mm) H = .932” (23.69mm) J = 1.735” (44.07mm) K = .283” (7.20mm) L = .175” (4.45mm) M = 1.27” (32.53mm) X = .115” (2.93mm)


	Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.