HS-325HB BB Deluxe


	ServoCity- Servos & Accessories- Hitec Servos- HS-325HB BB Deluxe-


	HS-325HB BB Deluxe

51 oz-in.

0.15 sec/60°


	The key to the great performance and durability of the HS-325HB servo is a combination of Karbonite gears, one peice circuit board and a ball bearing supported output shaft. The HS-325HB’s Karbonite gears are nearly 4 times stronger than nylon gears and provide virtually wear-free performance. You will not find another servo that offers all the features and durability of the HS-325HB for the same price!




	Detailed Specifications
	Control System: +Pulse Width Control 1500usec Neutral Required Pulse: 3-5 Volt Peak to Peak Square Wave Operating Voltage: 4.8-6.0 Volts Operating Temperature Range: -20 to +60 Degree C Operating Speed (4.8V): 0.19sec/60° at no load Operating Speed (6.0V): 0.15sec/60° at no load Stall Torque (4.8V): 42 oz/in (3.0 kg/cm) Stall Torque (6.0V): 51 oz/in (3.7 kg/cm) Current Drain (4.8V): 7.4mA/idle and 160mA no load operating Current Drain (6.0V): 7.7mA/idle and 180mA no load operating Dead Band Width: 5usec Operating Angle: 40 Deg. one side pulse traveling 400usec Direction: Clockwise/Pulse Traveling 1500 to 1900usec Motor Type: Cored Metal Brush Potentiometer Drive: 4 Slider/Direct Drive Bearing Type: Top Ball Bearing Gear Type: Heavy Duty Karbonite 360 Modifiable: Yes Connector Wire Length: 11.81" (300mm) Dimensions: See Schematics Weight: 1.52oz (43g)




	This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to use our servo stretcher for 180° operation.

Price:

$12.99

Part:

33325S

Status:

Rotation:

Direction:

Qty:


	A = .780” (19.82mm) B = .530” (13.47mm) C = 1.33” (33.79mm) D = .400” (10.17mm) E = .380” (9.66mm) F = 1.19” (30.22mm) G = .460” (11.68mm) H = 1.05” (26.67mm) J = 2.08” (52.84mm) K = .368” (9.35mm) L = .172” (4.38mm) M = 1.57” (39.88mm) X = .120” (3.05mm)


	Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.