HS-422 Super Sport


	ServoCity- Servos & Accessories- Hitec Servos- HS-422 Super Sport-


	HS-422 Super Sport

57 oz-in.

0.16 sec/60°


	The HS-422 has been around for a while and for a good reason, durability and the ability to be easily modified. For inexpensive robotic applications this the perfect servo. It can easily be modified for wheeled applications since the output shaft is supported on the botton and top with bronze bushings and the potentiometer is indirect drive. The circuit board is also seperate from the motor so the potentiometer can be easily accessed. Simply a great servo at a great price.




	This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to use our servo stretcher for 180° operation.

Price:

$12.49

Part:

31422S

Status:

Rotation:

Direction:

Qty:


	Detailed Specifications
	Control System: +Pulse Width Control 1500usec Neutral Required Pulse: 3-5 Volt Peak to Peak Square Wave Operating Voltage: 4.8-6.0 Volts Operating Temperature Range: -20 to +60 Degree C Operating Speed (4.8V): 0.21sec/60° at no load Operating Speed (6.0V): 0.16sec/60° at no load Stall Torque (4.8V): 45.82 oz/in. (3.3kg.cm) Stall Torque (6.0V): 56.93 oz/in. (4.1kg.cm) Operating Angle: 45 Deg. one side pulse traveling 400usec 360 Modifiable: Yes Direction: Clockwise/Pulse Traveling 1500 to 1900usec Current Drain (4.8V): 8mA/idle and 150mA no load operating Current Drain (6.0V): 8.8mA/idle and 180mA no load operating Dead Band Width: 8usec Motor Type: 3 Pole Ferrite Potentiometer Drive: Indirect Drive Bearing Type: Dual Oilite Bushing Gear Type: Nylon Connector Wire Length: 11.81" (300mm) Dimensions: See Schematics Weight: 1.6oz (45.5g)


	A = .780” (19.82mm) B = .530” (13.47mm) C = 1.33” (33.79mm) D = .400” (10.17mm) E = .380” (9.66mm) F = 1.19” (30.22mm) G = .460” (11.68mm) H = 1.05” (26.67mm) J = 2.08” (52.84mm) K = .368” (9.35mm) L = .172” (4.38mm) M = 1.57” (39.88mm) X = .120” (3.05mm)


	Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.