HS-45HB Premium Feather


	ServoCity- Servos & Accessories- Hitec Servos- HS-45HB Premium Feather-


	HS-45HB Premium Feather

13.88 oz-in.

0.14 sec/60°

The all new HS-45HB Premium Feather servo is quickly going to revolutionize the micro servo market. Most micro servos cut corners to save weight and this makes them not center correctly or fail too soon. The HS-45HB is loaded with features normally found on much larger standard size premium servos. In the HS-45HB you will find Hitec’s ground breaking Karbonite geartrain supported by ball bearings. They also designed a new patent pending layout for the gears so that the potentiometer is now connected directly to the circuit board. The is the most accurate, high quality micro servo we have ever tested!

This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to use our servo stretcher for 180° operation.

Price:

$21.99

Part:

33045S

Status:

Rotation:

Direction:

Qty:


	Detailed Specifications
	Control System: +Pulse Width Control 1500usec Neutral Required Pulse: 3-5 Volt Peak to Peak Square Wave Operating Voltage: 4.8 Volts Operating Temperature Range: -20 to 60 Degree C Test Voltage: 4.8 Volts Operating Speed: 0.14 sec/60° at no load Stall Torque: 13.883 oz/in. (1.0kg.cm) Operating Angle: 40° one side pulse traveling 400usec 360 Modifiable: No Direction: Clockwise/Pulse Traveling 1500 to 1900usec Current Drain: 8mA/idle and 100mA no load operating Dead Band Width: 8usec Motor Type: 3 Pole Ferrite Potentiometer Drive: Direct Drive Bearing Type: Ball Bearing Gear Type: All Karbonite Gears Connector Wire Length: 6.29" (160mm) Dimensions: See Schematics Weight: 0.28oz (8g)


		Included servo arms and mounting hardware.






		The HS-45HB is about the size of a quarter.


	A = .392” (9.96mm) B = .294” (7.48mm) C = .823” (20.90mm) E = .193” (4.90mm) F = .752” (19.09mm) G = .352” (8.93mm) H = .604” (15.35mm) J = 1.323” (33.60mm) K = .276” (7.00mm) L = .078” (1.98mm) M = .944” (23.99mm) X = .096” (2.43mm)


	Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.