HS-475HB Super Pro BB


	ServoCity- Servos & Accessories- Hitec Servos- HS-475HB Super Pro BB-


	HS-475HB Super Pro BB

76 oz-in.

0.18 sec/60°


	The HS-475HB has been discontinued and was replaced with the new HS-485HB servo.




	Detailed Specifications
	Control System: +Pulse Width Control 1500usec Neutral Required Pulse: 3-5 Volt Peak to Peak Square Wave Operating Voltage: 4.8-6.0 Volts Operating Temperature Range: -20 to +60 Degree C Operating Speed (4.8V): 0.23sec/60° at no load Operating Speed (6.0V): 0.18sec/60° at no load Stall Torque (4.8V): 61 oz/in. (4.3kg.cm) Stall Torque (6.0V): 76 oz/in. (5.5kg.cm) Operating Angle: 45 Deg. one side pulse traveling 400usec 360 Modifiable: Yes Direction: Clockwise/Pulse Traveling 1500 to 1900usec Current Drain (4.8V): 8mA/idle and 150mA no load operating Current Drain (6.0V): 8.8mA/idle and 180mA no load operating Dead Band Width: 8usec Motor Type: 3 Pole Ferrite Motor Potentiometer Drive: Indirect Drive Bearing Type: Top Ball Bearing, Lower Bushing Gear Type: Karbonite Gears Connector Wire Length: 11.81" (300mm) Dimensions: See Schematic Weight: 1.4oz (39g)


			Uses C1 Standard Spline


			Click for more information



	This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to purchase our servo stretcher for 180° operation.

Price:

$17.99

Part:

33475S

Status:

Discontinued see HS-485HB

Rotation:

Direction:

Qty:


	A = .780” (19.82mm) B = .560” (14.25mm) C = 1.31” (33.35mm) D = .390” (9.90mm) E = .390” (9.92mm) F = 1.13” (28.68mm) G = .427” (10.85mm) H = 1.05” (26.67mm) J = 2.09” (53.09mm) K = .370” (9.40mm) L = .174” (4.42mm) M = 1.53” (39.00mm) X = .125” (3.18mm)


	Copyright 1999-2009 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.