Detailed Specifications
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 4.8-6.0 Volt Peak to Peak Square Wave
Operating Voltage Range: 4.8-6.0 Volts
Operating Temperature Range: -20° to +60° C (-4°F to +140°F)
Operating Speed (4.8V): 0.12 sec/60° at no load
Operating Speed (6.0V): 0.10 sec/60° at no load
Stall Torque (4.8V): 16.6 oz/in. (1.2kg.cm)
Stall Torque (6.0V): 19.4 oz/in. (1.4kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Idle Current Drain (4.8V): 3mA at stop
Idle Current Drain (6.0V): 3mA at stop
Dead Band Width: 2usec
Motor Type: Carbon Brush
Potentiometer Drive: 6 Slider Indirect Drive
Bearing Type: Plastic
Gear Type: Metal Gears
Connector Wire Length: 7" (178mm)
Dimensions: .88" x 045"x .94" (22.6 x 11.6 x 24mm)
Weight: .45oz (12.7g)
|
|
19.4 oz-in. |
|
0.10 sec/60° |
*Digital servos do not need to be programmed to operate. They work great right out of the box and purchasing a programmer is not necessary.
Programable Features:
- Dead Band Width
- Direction of Rotation
- Speed of Rotation (slower)
- End Points (up to 120 degrees)
- Neutral Points
- Fail Safe On/Off
- Fail Safe Points
- Resolution (default is set at high)
- Overload Protection (default is off)
HS-5056MG B1 Mini Spline
The HS-5056MG Premium Digital Feather Servo is the perfect choice for larger indoor R/C, hand launch gliders, small electric Park flyers, and can handle the duties of smaller electric 3D aerobatic aircraft as well. Combined with a programmable digital amplifier, metal gears, and precision components that have been engineered to provide long lasting trouble free service, the HS-5056MG sets the standard for Digital, heavy duty, ultra micro servos. Along with a Hitec programmer, you can change a number of performance characteristics of the HS-5056MG. We offer this servo in several configurations, 90° stock rotation, 120° modified rotation (programmed), and reverse rotation.
HS-5056MG Hardware Set
This servo can be configured to operate 180° by using any of the following servo programmers:
Hitec HFP-25, HPP-21, HPP-21+
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
