Detailed Specifications
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 4.8-6.0 Volt Peak to Peak Square Wave
Operating Voltage Range: 4.8-6.0 Volts
Operating Temperature Range: -20° to +60° C (-4°F to +140°F)
Operating Speed (4.8V): 0.14 sec/60° at no load
Operating Speed (6.0V): 0.11 sec/60° at no load
Stall Torque (4.8V): 24.99oz/in. (1.8kg.cm)
Stall Torque (6.0V): 30.55oz/in. (2.2kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Idle Current Drain (4.8V): 3mA at stop
Idle Current Drain (6.0V): 3mA at stop
Current Drain (4.8V): 200mA/idle and 2.0 amps at lock/stall
Current Drain (6.0V): 240mA/idle and 3.0 amps at lock/stall
Dead Band Width: 2usec
Motor Type: Carbon Brush
Potentiometer Drive: 6 Slider Indirect Drive
Bearing Type: Top Ball Bearing
Gear Type: Metal Gears
Connector Wire Length: 7" (178mm)
Dimensions: See Schematics
Weight: .42oz (11.9g)
*Digital servos do not need to be programmed to operate. They work great right out of the box and purchasing a programmer is not necessary.
Programable Features:
- Dead Band Width
- Direction of Rotation
- Speed of Rotation (slower)
- End Points (up to 120 degrees)
- Neutral Points
- Fail Safe On/Off
- Fail Safe Points
- Resolution (default is set at high)
- Overload Protection (default is off)
Hitec just raised the bar by offering the ever popular HS-65 in a new digital version! The HS-5065MG High Performance Micro Servo features Hitecs digital, programmable circut for incredible resolution, centering and holding torque; also featuring metal gears, a top-ball bearing, and nearly 31 ounces/inches of torque with a quick transit time of 0.11 sec at 6 volts, it will no doubt be the choice for high performance micro helicopters, electric park flyers, 1/18 scale cars and light duty robotic projects. We offer the new HS-5065MG servo in several configurations, 90° stock rotation, 180° modified rotation (programmed) and reverse rotation.
|
|
30.55 oz-in. |
|
0.11 sec/60° |
The HS-5065MG Spline is smaller than the standard Hitec spline.
The HS-5065MG comes with two extra horns and mounting hardware.
This servo can be configured to operate 180° by using any of the following servo programmers:
Hitec HFP-25, HPP-21, HPP-21+
HS-5065MG B1 Mini Spline
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
