Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.17sec/60° at no load
Operating Speed (6.0V): 0.13sec/60° at no load
Stall Torque (4.8V): 41.66 oz/in. (3kg.cm)
Stall Torque (6.0V): 48.6 oz/in. (3.5kg.cm)
Standing Torque (4.8V): 83.32 oz/in. (6kg.cm)
Standing Torque (6.0V): 97.21 oz/in. (7kg.cm)
Operating Angle: 40 Deg. one side pulse traveling 450usec
360 Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 3mA/idle and 180mA no load operating
Current Drain (6.0V): 3mA/idle and 230mA no load operating
Dead Band Width: 1usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Direct Drive
Bearing Type: Dual Ball Bearing
Gear Type: 4 Metal Gears, 1 Metal Resin Gear
Connector Wire Length: 11.81" (300mm)
Dimensions: 1.14" x 0.51"x 1.18" (30 x 10 x 34mm)
Weight: 0.84oz (24g)
Detailed Specifications
|
|
49 oz-in. |
|
0.13 sec/60° |
The HS-5125MG is the thinest digital servo you can purchase. At only 1/2” thick, this servo is perfect for thin wings such as sailplanes. Digital circuitry means that the HS-5125MG can also be easily programmed with our hand held programmer. We offer this servo in several configurations, 90° stock rotation, 180° modified rotation and reverse rotation. You do need to know that the spline is different than standard Hitec servos. It is smaller so standard horns from other Hitec servos will not fit. Be sure to check out our manufactured horns that will work with the HS-125MG and the HS-5125MG
HS-5125MG B1 Mini Spline
This servo can only operate 90° due to the design of the internal gears. Over-driving may cause damage.
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Copyright 1999-2011 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.