Detailed Specifications
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 6.0-7.4 Volt Peak to Peak Square Wave
Operating Voltage Range: 6.0-7.4 Volts
Operating Temperature Range: -20° to +60° C (-4°F to +140°F)
Operating Speed (6.0V): 0.20sec/60° at no load
Operating Speed (7.4V): 0.18sec/60° at no load
Stall Torque (6.0V): 157oz/in. (11.3kg.cm)
Stall Torque (7.4V): 179oz/in. (12.9kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
Continuous Rotation Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Dead Band Width: 2usec
Motor Type: 3 Pole Ferrite
Bearing Type: Dual Ball Bearings
Gear Type: 3 Metal Gears and 1 Nylon Gear
Connector Wire Length: 7" (178mm)
Dimensions: 1.65” x 0.83” x 1.57" (41.8 x 21 x 40mm)
Weight: 2.15oz (61g)
|
|
179.14 oz-in. |
|
0.18 sec/60° |
This servo can be configured to operate 180° by using any of the following servo programmers:
Hitec HFP-25, HPP-21, HPP-21+
*Digital servos do not need to be programmed to operate. They work great right out of the box and purchasing a programmer is not necessary.
Hitec’s new waterproof servos have what it takes to keep your radio control vehicle, airplane or robot watertight! With high torque, dual ball bearings and metal gears, this digital waterproof servo has the industry’s first IP67 rating, ranking it among the most durable and reliable servos for wet conditions. Whether you are manning your power boat, bashing in the mud, directing your underwater robot, or water landing your 25% plane, the HS-5645WP will dependably keep your mind at ease!
Uses C1 Standard Spline
Included servo horns and hardware
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
Features:
- Metal Gear with MP First Gear
- Dual Ball Bearings
- Industry’s First IP67-rated Waterproof Case
IP = International Protection Code
6 = Dust Tight, 7 = Immersion up to 1M
- 2 Cell LiPo Capability
- Programmable Circuit
Please note: The case on the waterproof servos is slightly larger than the case on standard size Hitec servos. Therefore, the waterproof servos are not compatible with our power gearboxes, ServoBlocks, or Pan & Tilt kits.
Hitec Servo Accessories
Click on the picture for further information.
Servo Screws
Servo Hardware
Servo Extensions
Servo Arms
Hitec Casesets
Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Proud Distributor of
