The Hitec HS-56HB continues the Hitec tradition of affordable performance. Featuring precision components that have been engineered to provide long lasting trouble free service. The HS-56HB is the perfect choice for any micro application from indoor R/C and hand launch gliders, to ultra small electric Park and Yard flyers, Speed 400 and 1/2A powered aircraft. This servo can also be modified for continuous rotation for building wheeled micro robots. See the link below for instructions on how to perform this modification.
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.12sec/60° at no load
Operating Speed (6.0V): 0.10sec/60° at no load
Stall Torque (4.8V): 16.66 oz/in. (1.2kg.cm)
Stall Torque (6.0V): 19.44 oz/in. (1.4kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
Continuous Rotation Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 5.3mA/idle and 400mA no load operating
Current Drain (6.0V): 6.6mA/idle and 500mA no load operating
Dead Band Width: 4usec
Motor Type: 3-Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: Top Ball Bearing
Gear Type: Karbonite Gears
Connector Wire Length: 11.81" (300mm)
Dimensions: 88" x 0.45"x 94" (23 x 12 x 24mm)
Weight: .39oz. (11.2g)
This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to use our servo stretcher for 180° operation.
HS-56HB B1 Mini Spline
Hitec Servo Accessories
Click on the picture for further information.
Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
Proud Distributor of