|
|
343 oz-in. |
|
0.14 sec/60° |
*Digital servos do not need to be programmed to operate. They work great right out of the box and purchasing a programmer is not necessary.
Programable Features:
- Dead Band Width
- Direction of Rotation
- Speed of Rotation (slower)
- End Points (up to 180 degrees)
- Neutral Points
- Fail Safe On/Off
- Fail Safe Points
- Resolution (default is set at high)
- Overload Protection (default is off)
15 tooth metal spline
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.19sec/60° at no load
Operating Speed (6.0V): 0.14sec/60° at no load
Stall Torque (4.8V): 274.96 oz/in. (19.8kg.cm)
Stall Torque (6.0V): 343.01 oz/in. (24.7kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8mA/idle and 700mA no load operating
Current Drain (6.0V): 8.7mA/idle and 830mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: 4 Metal Gears and 1 Heavy Duty Nylon Gear
Connector Wire Length: 11.81" (300mm)
Dimensions: 2.59" x 1.18"x 2.26" (66 x 30 x 57.6mm)
Weight: 6.95 oz. (197g)
Detailed Specifications
The all new HS-5805MG offers the power of the HS-805BB combined with digital technology and metal gears. At 6 volts, this servo unleashes an amazing 343 oz-in. of torque. Dual ball bearings, metal gears, heavy duty digital H-bridge and large 15 tooth output spline enable the HS-5805MG to handle almost anything. When assembled in our SPG800A 5:1 ratio kit, 1,715 oz-in. of torque is at your disposal. We offer this servo in several configurations, reverse rotation, 180° rotation and continuous rotation for wheeled applications.
This servo can be configured to operate 180° by using any of the following servo programmers:
Hitec HFP-25, HPP-21, HPP-21+
D1 Heavy Duty Spline
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
