HS-645MG Ultra Torque


	ServoCity- Servos & Accessories- Hitec Servos- HS-645MG Ultra Torque-


	HS-645MG Ultra Torque

133 oz-in.

0.20 sec/60°


	The HS-645MG is one of our favorite servos of all time. We use this servo for all types of robotic applications and industrial products. The reliability and performance that you get for under $40 is fantastic. Metal gears, dual ball bearings, seperated motor and circuit board make the HS-645MG a top choice whether your project is robotics, aircraft, cars or trucks. We offer the HS-645MG in several configurations, 90° stock rotation, 180° modified rotation, continuous rotation (potentiometer is left outside the servo case) and reverse rotation.




	Detailed Specifications
	Control System: +Pulse Width Control 1500usec Neutral Required Pulse: 3-5 Volt Peak to Peak Square Wave Operating Voltage: 4.8-6.0 Volts Operating Temperature Range: -20 to +60 Degree C Operating Speed (4.8V): 0.24sec/60° at no load Operating Speed (6.0V): 0.20sec/60° at no load Stall Torque (4.8V): 106.93 oz/in. (7.7kg.cm) Stall Torque (6.0V): 133.31 oz/in. (9.6kg.cm) Operating Angle: 45 Deg. one side pulse traveling 400usec 360 Modifiable: Yes Direction: Clockwise/Pulse Traveling 1500 to 1900usec Current Drain (4.8V): 8.8mA/idle and 350mA no load operating Current Drain (6.0V): 9.1mA/idle and 450mA no load operating Dead Band Width: 8usec Motor Type: 3 Pole Ferrite Potentiometer Drive: Indirect Drive Bearing Type: Dual Ball Bearing Gear Type: 3 Metal Gears and 1 Resin Metal Gear Connector Wire Length: 11.81" (300mm) Dimensions: 1.59" x 0.77"x 1.48" (40.6 x 19.8 x 37.8mm) Weight: 1.94oz. (55.2g)




	This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to purchase our servo stretcher for 180° operation.

Price:

$39.99

Part:

32645S

Status:

Rotation:

Direction:

Qty:


	Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.