HS-7115TH Servo

54.16 oz-in.

0.10 sec/60°

You can never be too rich or too thin! That's Hitec’s philosophy with the new HS-7115TH Slim Wing servo: rich engineering in a thin design! The HS-7115TH will fulfill every pilot's dream when it comes to flying slim-wing aircraft. With its efficient, powerful three pole, metal-brushed motor and mighty titanium gear train, this servo brings the ultimate in high performance to your sailplanes, pylon racers and smaller scale models. The extremely thin, 8mm case with included mounting bracket allows it to fit into the tightest wings and most compact spaces. Constructed with dual ball bearings, the high voltage HS-7115TH provides an impressive 50 oz-in of torque at 7.4 volts

Detailed Specifications

Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 6.0-7.4 Volt Peak to Peak Square Wave
Operating Voltage Range: 6.0-7.4 Volts
Operating Temperature Range: -20° to +60° C (-4°F to +140°F)
Operating Speed (6.0V): 0.12sec/60° at no load
Operating Speed (7.4V): 0.10sec/60° at no load
Stall Torque (6.0V): 44.44 oz/in. (3.2 kg.cm)
Stall Torque (7.4V): 56.14 oz/in. (3.9 kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
Continuous Rotation Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Dead Band Width: 2usec
Motor Type: 3 Pole Metal Brush with Ferrite Magnets
Bearing Type: Dual Ball Bearings
Gear Type: Titanium Alloy Metal Gears
Connector Wire Length: 11.8” (30mm)
Dimensions: 1.02” x 0.31” x 1.50” (26 x 8 x 38mm)
Weight: 0.71oz (20g)

This servo can be configured to operate 180° by using any of the following servo programmers:
Hitec HFP-25, HPP-21, HPP-21+

HS-7115TH included hardware

Features:
- 2 cell Li-Po (6 cell NiMH) Compatible
- High Standing Torque
- Gold Plated Connector
- Ultra Slim Wing
- Durable Titanium Alloy Metal Gears with Dual Ball Bearings
- Programmable Digital Amplifier w/ MOSFET drive

The included mounting bracket allows it to fit into the tightest wings and most compact spaces.