Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.18sec/60° at no load
Operating Speed (6.0V): 0.14sec/60° at no load
Stall Torque (4.8V): 61.1 oz/in. (4.4kg.cm)
Stall Torque (6.0V): 76.3 oz/in. (5.5kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8mA/idle and 250mA no load operating
Current Drain (6.0V): 8.8mA/idle and 290mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: Top Ball Bearing
Gear Type: 1 Metal and 4 POM Resin Gears
Connector Wire Length: 10.2" (260mm)
Dimensions: 1.73" x 0.90"x 0.98" (44 x 23 x 25mm)
Weight: 1.23oz (35g)
Detailed Specifications
The HS-77BB is a low profile servo. In applications where a standard servo is too deep, this servo will usually work extremely well. Although it is very shallow, it still manages to produce a very respectable 76 oz-in. of torque at 6 volts with a fast .14 sec. travel time. All standard Hitec horns and arms will fit since it utilized Hitecs 24 tooth standard spline configuration. We offer the HS-77BB in several setups, 180° rotation, continuous rotation and reverse rotation.
|
|
76 oz-in. |
|
0.14 sec/60° |



Uses C1 Standard Spline
Copyright 1999-2011 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.