HS-7985MG Servo


	ServoCity- Servos & Accessories- Hitec Servos- HS-7985MG Servo-


	HS-7985MG Servo

172 oz-in.

0.13 sec/60°

Replacing the HS-5985MG, our new premium high speed HS-7985MG Digital Servo has the added benefit of our new G2 second generation programmable digital circuit. This circuit has twice the resolution of our original circuit while adding programmable overload protection. The technology doesn’t stop at the circuit board, with high performance coreless motors, dual ball bearings, bushing supported gear shafts, dual ball bearing output shaft and our Heavy Duty Metal gear train the HS-7985MG will give you everything you need no matter what the demand. We offer the HS-7985MG servo in several configurations, 90° stock rotation, 180° modified rotation, continuous rotation (potentiometer is left outside the servo case) and reverse rotation.

*Digital servos do not need to be programmed to operate. They work great right out of the box and purchasing a programmer is not neccessary.




	This servo can be configured to operate 180° two ways. Option 1, send a pulse signal ranging from 600usec to 2400usec. Option 2, use a Hitec HFP-20 programmer to modify the internal servo program.


	Programable Features: - Dead Band Width - Direction of Rotation - Speed of Rotation (slower) - End Points (up to 180 degrees) - Neutral Points - Fail Safe On/Off - Fail Safe Points - Resolution (default is set at high) - Overload Protection (default is off)

	Detailed Specifications
	Control System: +Pulse Width Control 1500usec Neutral Required Pulse: 4.8-6.0 Volt Peak to Peak Square Wave Operating Voltage Range: 4.8-6.0 Volts Operating Temperature Range: -20 to +60 Degree C (-68F to +140F) Operating Speed (4.8V): 0.16sec/60° at no load Operating Speed (6.0V): 0.13sec/60° at no load Stall Torque (4.8V): 144oz/in. (10.4kg.cm) Stall Torque (6.0V): 172oz/in. (12.4kg.cm) Operating Angle: 45 Deg. one side pulse traveling 400usec 360 Modifiable: Yes Direction: Clockwise/Pulse Traveling 1500 to 1900usec Idle Current Drain (4.8V): 3mA at stop Idle Current Drain (6.0V): 3mA at stop Current Drain (4.8V): 200mA/idle and 2.0 amps at lock/stall Current Drain (6.0V): 240mA/idle and 3.0 amps at lock/stall Dead Band Width: 2usec Motor Type: Coreless Carbon Brush Potentiometer Drive: 6 Slider Indirect Drive Bearing Type: Dual Ball Bearing MR106 Gear Type: 3 Metal, 1 Metal Karbonite Gear Connector Wire Length: 7" (178mm) Dimensions: 1.57" x 0.78"x 1.45" (40 x 20 x 37mm) Weight: 2.18oz (62g)


		HS-7985MG Hardware Set

Price:

$94.99

Part:

37985S

Status:

Rotation:

Direction:

Qty:


	Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved ServoCity is a registered trademark of Robotzone, LLC.