Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.19sec/60° at no load
Operating Speed (6.0V): 0.14sec/60° at no load
Stall Torque (4.8V): 274.96 oz/in. (19.8kg.cm)
Stall Torque (6.0V): 343.01 oz/in. (24.7kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
Continuous Rotation Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8mA/idle and 700mA no load operating
Current Drain (6.0V): 8.7mA/idle and 830mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: All Heavy Duty Nylon Gears
Connector Wire Length: 11.81" (300mm)
Dimensions: 2.59" x 1.18"x 2.26" (66 x 30 x 57.6mm)
Weight: 5.36 oz. (152g)
Detailed Specifications
If you are needing power, look no further than the HS-805BB servo. At 6 volts, this servo unleashes an amazing 343 oz-in. of torque. Dual ball bearings, extra thick nylon gears, heavy H-bridge and large output spline enable the HS-805BB to handle almost anything. When assembled in our SPG800 5:1 ratio kit, 1,715 oz-in. of torque is at your disposal. We offer this servo in several configurations, reverse rotation, 180° rotation and continuous rotation for wheeled applications.
|
|
343 oz-in. |
|
0.14 sec/60° |
D1 Heavy Duty Spline
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
Hitec Servo Accessories
Click on the picture for further information.
Servo Screws
Servo Hardware
Servo Extensions
Servo Arms
Hitec Casesets
Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Proud Distributor of
