Detailed Specifications
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 4.8-6.0 Volt Peak to Peak Square Wave
Operating Voltage Range: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C (-4F to +140F)
Operating Speed (4.8V): 44 RPM at no load
Operating Speed (6.0V): 52 RPM at no load
Operating Torque (4.8V): 38.8 oz-in (2.8 kg-cm)
Operating Torque (6.0V): 42 oz-in (3.1 kg-cm)
Continuous Rotation Modifiable: Completed (Stock)
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Idle Current Drain (4.8V): 3mA at stop
Idle Current Drain (6.0V): 3mA at stop
Motor Type: Brushed
Potentiometer Drive: No Potentiometer
Bearing Type: Dual Ball Bearing MR106
Gear Type: Nylon Gears
Connector Wire Length: 7" (178mm)
Dimensions: 1.59" x 0.77"x 1.44" (40.6 x 19.8 x 36.6mm)
Weight: 1.47oz (41.7g)
|
|
42 oz-in. |
|
52 RPM (6V) |
Introducing the all new HSR-1425CR Continuous Rotation servo. If you are looking for a servo to pan or tilt your small camera or sensor multiple turns, this is the servo you need. If you are looking for a servo to power the wheels on your small robot, this is the servo you need. Fully proportional speed forward and reverse for precise movements. The potentiometer has been taken out and the dead-band increased to eliminate “creep” that occurs in many other servos that are modified for continuous rotation. Dual ball bearings on the output shaft ensure long lasting performance. Note: This servo does not have position feedback.
Our shaft adaptors work great with the HSR-1425CR servo.
Uses C1 Standard Spline
Hitec Servo Accessories
Click on the picture for further information.
Servo Screws
Servo Hardware
Servo Extensions
Servo Arms
Hitec Casesets
Bolt on one of our aluminum servo hubs and then choose one of our many wheels to attach.
Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Proud Distributor of
