Features:
Hitec Proprietary HMI
Parameter Setting Capability
Data Feedback (Position, Current, Voltage)
RS-232C Daisy Chain Interface up to 128 servos
Flexible Mechanism Design
Dual Axis Mount
Heavy Duty Karbonite Gears
Dual Ball Bearing
MOS Fet Drives

This servo can be configured to operate 180° two ways. Option 1, send a pulse signal ranging from 600usec to 2400usec. Option 2, use the HMI Programmer to modify the internal servo program.

Detailed Specifications

Interface: HMI Protocol, RS-232C Daisy Chain, PWM
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Pulse Cycle: 12-26ms (Common: 21ms)
Operating Voltage: 6-7.4Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (6.0V): 0.20sec/60° at no load
Operating Speed (7.4V): 0.18sec/60° at no load
Stall Torque (6.0V): 102 oz/in. (7.4kg.cm)
Stall Torque (7.4V): 124 oz/in. (9.0kg.cm)
Operating Angle: Up to 180° Max
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1100 to 1900usec
Current Drain (6.0V): 8mA/idle and 200mA no load operating
Current Drain (7.4V): 8.7mA/idle and 240mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: Karbonite Gears
Connector Wire Length: 15.87" (400mm)
Dimensions: 1.57" x .78"x 1.45" (40 x 20 x 37mm)
Weight: 1.94 oz.. (55g)

The HSR-8498HB has a drive side and a freewheel side. It is designed this way for various attachments.

The HSR-8498HB comes with an extra case with screws and horns

Copyright 1999-2008 Robotzone. LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.