• Adjustable Framework
• Aluminum Hollow Shafts
• 6061-T6 Aluminum Construction (Anodized)
• 32 Pitch Gear Drive
• Precision Gearmotors
• 12 Volt Operation
• Fully Assembled
• Pan & Tilt Head
• Joystick Control (Proportional)
• 25’ CAT6 Cable
• 12V Power Supply
Introducing the new MPT1100-SS pan and tilt system from ServoCity! The pan and tilt head is the ideal size for DSLR and smaller bodied cameras. The super light 6061 T6 aluminum structure weighs in at only 2.2lbs, yet is able to handle up to a 6 pound payload! Dual ball bearings on each axis support the 1” hollow aluminum shafting allowing you to route camera wires through the pan and tilt head. The head easily attaches to a jib crane in the upright or hanging position without any tools (Jib Mounting Kit sold separately). The MPT1100-SS is precisely controlled by a new digital joystick controller. The two channel controller is fully proportional and the maximum speed of each axis can be limited by the min/max knobs for the ultra-slow shots. Setup is quick and easy as the controller links to the pan and tilt head with a single CAT6 cable and is powered by a 12V power supply. The system ships as a ready-to-run unit that includes a pan & tilt head, joystick control, 25 foot CAT6 cable, and 12V power supply. Camera shown in images not included. Patented.
Upright or hanging position
The MPT1100-SS head weighs just 2.9 pounds!
Balancing your camera is easy using the vertical slide adjustment.
MPT1100-SS Jib Mounting Kit
The pan and tilt head is the ideal size for DSLR and smaller bodied cameras.
The 20 RPM Precision Gearmotors (5:1 ratio) provide a precise and smooth pan and tilt motion.
Think this is cool?
Share with your friends!
• 90mm ABS Spacer
• 3/8” - 16 Carriage Bolt
• 3/8” Washer
• 3/8” - 16 Wing Nut
The MPT1100-SS pan and tilt quickly and easily attaches to most jib cranes using the Jib Mounting Kit.
Click here to download the MPT1100-SS User’s Guide.
For additional CAT6 cable lengths click here
The included 1” bar clamp allows you to easily attach the joystick controller to the weight bar of a jib crane.
Bottom Plate Dimensions
Click here to view the MPT1100-SS demo video.
Click here for POV video of the MPT1100-SS shooting a Porsche 917!
Need to control additional gearmotors?
Auxiliary Joystick Control
This controller is to be used in conjunction with the Joystick Controller (main controller) that comes with the MPT1100-SS. The auxiliary controller simply plugs into the main controller via the provided 3’ CAT6 cable and allows the user to proportionally control 2 additional gearmotors.
Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
Proud Distributor of