MEGA SERVO
Programable Features:
- Dead Band Width
- Direction of Rotation
- Speed of Rotation (slower)
- End Points (up to 180 degrees)
- Neutral Points
- Fail Safe On/Off
- Fail Safe Points
- Resolution
- Overload Protection
Up to 2,000 oz-in of torque!
This servo comes stock with 90 degree rotation. However, you can purchase this servo pre-modified to 180 degrees.
Introducing the all-new line of Robotzone Digital Mega Servos. The MS530-1 Mega Servo is able to deliver up to 2000 oz-in (144 kg-cm) of torque with a transit time of 0.9 seconds/60 degrees (on 7.4VDC)! The Mega Servos plug into any servo controller or receiver just like a regular sized hobby servo. With an operating voltage of 4.8-7.4VDC, the Mega Servos are able to be run in unison with hobby servos without the hassle of using a separate power source. The robust 6061-T6 anodized aluminum structure and 1” OD output shaft can handle even the toughest applications Whether building a robot, a mega-sized R/C vehicle or if you have a custom application that demands mega torque, the Robotzone Digital Mega Servos will deliver! Patented
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
Gold Plated Pins
1” OD output shaft
Connects directly to a servo controller
Shown with 1” Heavy Duty Clamping Hub
Shown with 1” Lightweight Clamping Hub
6-32 tapped output shaft
1” OD shaft
6061-T6 anodized aluminum
Detailed Specifications
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 4.8-7.4 Volt Peak to Peak Square Wave
Operating Voltage Range: 4.8-7.4 Volts
Operating Temperature Range: -20 to +60 Degree C (-68F to +140F)
Operating Speed (7.4V): 0.90 sec/60° at no load
Stall Torque (7.4V): 2,000oz/in. (144 kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Dead Band Width: 1usec
Motor Type: Coreless Carbon Brush
Potentiometer Drive: 6 Slider Indirect Drive
Bearing Type: Dual Ball Bearing MR106
Gear Type: Titanium, Aluminum, Brass Gears
Connector Wire Length: 6" (150mm)
Weight: 1.14 lbs
Weight: 1.34 lbs
Video Coming Soon!
6” Mega Servo Double Arm
The Mega servo arms use
6-32 x 1/2” pan head Phillips screws.
Click here for more information
This product utilizes a 0.770” hub pattern
3” Mega Servo Single Arm
Think this is cool?
Share with your friends!
Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Proud Distributor of
