Channels: 8
Band: 2.4GHz
Conversion: FASST (Spread Spectrum)
Operating Voltage: 3.7 ~ 7.4 Volts
Range: 6,000+ Feet
Antenna Length: 5”
Dimensions: 0.98 x 1.86 x 0.56 in (24.9 x 47.3 x 14.3mm)
Weight: 0.49oz. (13.8g)

Detailed Specifications

Works with:
T8FG 2.4GHz (on 8ch mode)
TM8 (on 8ch mode)
T10CG 2.4GHz (on 10ch mode)
TM10 (on 10ch mode)
TM14 (on multi-ch mode)

A short plug is included for connection to the DATA port when an S.Bus channel is set.

This is the Futaba R6208SB 8 Channel 2.4Ghz FASST S.Bus Receiver. Stop cable clutter with the innovative S.Bus system. It uses digital serial data communication technology to transmit control signals between your receiver and servos. A single S.Bus cable can carry signals to as many channels as your transmitter can handle. You no longer have to worry about plugging in the wrong servo to the wrong channel, because each servo knows what channel it is dedicated to in advance. S.Bus receivers are limited only by the number of channels your transmitter will handle. Don’t have S.Bus servos? No problem. SBD-1 S.Bus Decoder Cables let you use existing analog and digital servos too.

Features:
-Utilizes digital serial communication technology to transmit control signals between the receiver and servos using S.Bus hubs and cables
-Easy programming with the SBC-1 Channel Setting Tool, S-Bus receivers or PCLink software
-SBD-1 decoder cables (not included) allow the use of existing analog and digital servos
-Handles 8 channels without S.Bus usage or as many as the available number of channels on transmitter with S.Bus use.
-Prevents mismatched servo/channel connections
-Full-range receiver with DAD (Dual Antenna Diversity) that can be used in any flight application

Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.