|
|
69.4 oz-in. |
|
0.21 sec/60° |



Uses a 3F Standard Spline (25T)
Control System: +Pulse Width Control 1520usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.26sec/60 degrees at no load
Operating Speed (6.0V): 0.21sec/60 degrees at no load
Stall Torque (4.8V): 55 oz/in. (5.5kg.cm)
Stall Torque (6.0V): 69.4 oz/in. (7.1kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Counter Clockwise/Pulse Traveling 1520-1900usec
Motor Type: Coreless Motor
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: All Nylon Gears
Connector Wire Length: 12"
Dimensions: 1.6" x 0.8"x 1.4" (41 x 20 x 36mm)
Weight: 1.8oz. (50g)
Detailed Specifications
Futaba Servo Accessories
Click on the picture for further information.
Servo Screws
Servo Hardware
Servo Extensions
Servo Arms
Futaba Casesets

Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
Proud Distributor of