(5-40 size screws not included, click here to purchase screws)
Features:
• (4) 5-40 tapped holes
• (4) #5 Countersunk Holes
• Fits directly to servo spline
• Machined from 6061 T6 Aluminum
• Available for both Hitec & Futaba
(Standard Size Splines)
Servo Hub mounted on HS-785HB
Introducing our new, super strong, Servo Hub Horns. These new horns are machined from 6061 T6 aluminum and tapped with (4) 5-40 holes and (4) non-tapped countersunk (from the bottom) holes. They mate up perfectly with our wheels and gears that utilize the same hole pattern. Designed to work with standard Hitec or standard Futaba splines. Will not work on the HS-800 series servos at this time.
Servo hub works great for mounting our foam wheels directly to a servo.
(4) #5 holes are countersunk from the backside to allow countersunk screws to protrude through the top as shown above.
Being able to run screws from the bottom allows a variety of attachments.
The tube clamp hub is attached to the servo hub.
Attached to a Futaba S3004 Servo.
Attached to Heavy Duty servo arm.
Uses C1 Standard Hitec Spline
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Copyright 1999-2011 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.