The pan servo is mounted to the ball bearing plate and spaced off with (4) threaded posts. The 1/4” shaft is supported by a ball bearing.
Our SPT200 Direct Drive Pan & Tilt System is perfect for cameras or sensor up to 2lbs. The rigid 1/4” ABS plastic platform and aluminum servo horns on each axis make this compact pan and tilt system very rigid. Each axis is supported by a 1/4” precision ball bearing which allows the servos to handle loads applied from any direction. The 1/4” thru-holes in the top plate make it easy to mount a camera or sensor. The top plate can easily be drilled to accept other attachments if needed. The SPT200 will accept any standard size Hitec or Futaba servo (2 servos are required to assemble the kit). For loads up to 1lb, the HS-485HB or HS-645MG servos work very well. For loads exceeding 1lb, the HS-5685MH works well. For the ultimate in torque and precision, the HS-7950TH is recommended. Units come in kit form with a full set of instructions. Servos are not included and must be purchased separately (please choose the SPT200H if you intend to use Hitec servos; SPT200F if Futaba).
Our aluminum clamping hub is incorporated into the bottom for easy removal and optional attachment to other items.
The ball bearing pan plate has six holes for easy mounting to various surfaces.
Weight (no servos): 5.5 oz.
Tray Swing: 135°
Servos: 2 Standard Size (Hitec or Futaba) not included
Maximum Payload Weight: 2 pounds
Position: Hanging, Upright or Sideways
Click here to watch a video of our SPT200 Pan & Tilt in action!
Think this is cool?
Share with your friends!
DDP-BM Base Mount Kit
Shown with optional base mount kit. The .770” hub pattern opens up a multitude of mounting options including clamping hubs, channel, screw plates and brackets.
This product utilizes a
0.770” hub pattern.
Copyright 1999-2013 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
Proud Distributor of