Leads to connect your battery or power supply

.785” Diameter Extension Rod with .250” mounting hole

Gold-plated connector with twisted 22 gauge wire.

5 amp fuse protection

Introducing our all new Heavy Duty Linear Servo. Designed to run on a 7.2V-12.0V battery or power supply (8 amp minimum) and plug directly into your receiver or any other type of servo controller. Advanced digital control gives you precise, accurate movements. The digital controller will also supply your receiver or any other type of servo controller with 5V at 1.5 amps so you do not need a separate battery. All aluminum construction ensures tremendous durability and reliability. Offered in stroke lengths from just under 2.00 inches up to slightly under 12.00 inches. Extension shaft is .785” diameter. Mounting points are 1/4” diameter and bolt up directly to our optional mounting brackets. 

Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 6.0-12 Volts DC
Operating Temperature Range: -20 to +60 Degree C
-13 to +149 Degrees F
Operating Speed (12V): 2.20” second at No load
Operating Speed (12V): 1.37” second at Max load
Dynamic Thrust (12V): 25 lbs. Thrust
Static Load: 500 lbs.
Fully Retracted: 2000usec Pulse Width
Half Extended: 1500usec Pulse Width
Fully Extended: 1000usec Pulse Width
Current Drain (12V): 11.9mah Idle
Current Drain (12V): 800mah operating No load
Current Drain (12V): 3200mah operating Max load
Dead band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer: I0K
Gear Type: 4 Metal Gears
Connector Wire Length: 24"
Recommended Fuse: 5amp Inline Blade Fuse
IP Grade: 2IP 63-total dust protection, water resistant
Duty Cycle: 25% (25% on, 75% off)
Load force: 224.8 lbs
Static load capacity: 517 pounds
Housing Material: Zinc Alloy
IP65 Protection

Mounting Bracket

Aluminum stroke rod and outer tube

Detailed Specifications

Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.