Be sure to check out our new Servo Protractor (angle tester). Works perfect for setting up multiple digital servos to the same angle.

Programming servos just got easier...and more affordable. Hitec is proud to introduce their new HFP-25 Digital Servo Field Programmer and Tester. With its lightweight, streamlined case and rechargeable NiMH battery pack, this programmer is a must have for all hobbyists looking to program Hitec’s digital series of servos. The easy-to-read LCD screen, low battery warning and both manual and automatic testing capabilities make this programmer top notch!

The HFP-25 will program the following features of these Hitec digital servos:
- All Hitec digital servos: Servo speed, dead band width, direction of rotation, fail-safe and position program.
- All HS-7XXX G2 servos: Fully programmable, including OLP Rate and high resolution adjustments.
- HS-50XX Digital Micro Servos: Overload protection

Functions:
Transmitter Pulse Width Measurement
Receiver Voltage Measurement
Direction of Rotation
Speed of Rotation
Fail Safe On-Off
End Point
Neutral Point
Fail Safe Point Preset
Rechargeable NiMH Battery Pack
Overload Protection Setting*
Servo Resolution Mode Setting*
* Applicable to Hitec’s HS-7XXX series of digital servos only

Servo tester features (for any brand of servo):
- Manual and automatic test
- Receiver pulse width and receiver voltage measurement

Powering the HFP-25:
The HFP-25 used 4 cell 4.8V NiMh rechargeable battery pack to power the test and programming functions. (The rechargeable battery’s capacity should be more than 1300mA for optimal operation).

Low Battery Warning - If the programmer’s voltage becomes below 4 volts, the programmer’s LCD screen will flash “LOW BATT”. Programming should be avoided at low voltage.

4.8V 4 cell battery included

Click Here to view the instruction manual

Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.