Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.14sec/60° at no load
Operating Speed (6.0V): 0.11sec/60° at no load
Stall Torque (4.8V): 54.15 oz/in. (3.9kg.cm)
Stall Torque (6.0V): 66.65 oz/in. (4.8kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8mA/idle and 300mA no load operating
Current Drain (6.0V): 8.8mA/idle and 340mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: 1 Ball Bearing and 1 Oilite Bushing
Gear Type: Nylon
Connector Wire Length: 11.81" (300mm)
Dimensions: 1.27" x 0.66"x 1.22" (32.4 x 16.8 x 31mm)
Weight: 0.95oz (27g)
Detailed Specifications
HS-225BB servos have been around for sometime now and for a good reason, performance and durability. This little servo offers the same and sometimes more power than standard size servos. The main gear rests on a single ball bearing on top and a bronze bearing on the bottom. The spline is standard Hitec 24 tooth so any standard Hitec horn or arms will fit perfectly.
|
|
67 oz-in. |
|
0.11 sec/60° |
This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to use our servo stretcher for 180° operation.
A = .660” (16.77mm)
B = .470” (11.95mm)
C = 1.06” (26.94mm)
D = .310” (7.87mm)
E = .328” (8.35mm)
F = .942” (23.94mm)
G = .380” (9.66mm)
H = .932” (23.69mm)
J = 1.735” (44.07mm)
K = .283” (7.20mm)
L = .175” (4.45mm)
M = 1.27” (32.53mm)
X = .115” (2.93mm)
Uses C1 Standard Spline
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Copyright 1999-2011 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.