HS-45HB Premium Feather

Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8 Volts
Operating Temperature Range: -20 to 60 Degree C
Test Voltage: 4.8 Volts
Operating Speed: 0.14 sec/60° at no load
Stall Torque: 13.88 oz/in. (1.0kg.cm)
Operating Angle: 40° one side pulse traveling 400usec
360 Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain: 8mA/idle and 100mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Direct Drive
Bearing Type: Top Ball Bearing
Gear Type: All Karbonite Gears
Connector Wire Length: 6.29" (160mm)
Dimensions: See Schematics
Weight: 0.28oz (8g)

The all new HS-45HB Premium Feather servo is quickly going to revolutionize the micro servo market. Most micro servos cut corners to save weight and this makes them not center correctly or fail too soon. The HS-45HB is loaded with features normally found on much larger standard size premium servos. In the HS-45HB you will find Hitec’s ground breaking Karbonite gear train supported by ball bearings. They also designed a new patent pending layout for the gears so that the potentiometer is now connected directly to the circuit board. The is the most accurate, high quality micro servo we have ever tested!

Detailed Specifications

13.88 oz-in.

0.14 sec/60°

Price:

$15.99

Part:

33045S

Status:

Rotation:

Direction:

Qty:

Included servo arms and mounting hardware.

This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to use our servo stretcher for 180° operation.

The HS-45HB is about the size of a quarter.

A = .392” (9.96mm)
B = .294” (7.48mm)
C = .823” (20.90mm)
E = .193” (4.90mm)
F = .752” (19.09mm)
G = .352” (8.93mm)
H = .604” (15.35mm)
J = 1.323” (33.60mm)
K = .276” (7.00mm)
L = .078” (1.98mm)
M = .944” (23.99mm)
X = .096” (2.43mm)