|
|
13.88 oz-in. |
|
0.12 sec/60° |
Included servo horns and hardware
*Digital servos do not need to be programmed to operate. They work great right out of the box and purchasing a programmer is not necessary.
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8 Volts
Operating Temperature Range: -20 to 60 Degree C
Test Voltage: 4.8 Volts
Operating Speed: 0.12 sec/60° at no load
Stall Torque: 13.88 oz/in. (1.0kg.cm)
Operating Angle: 40° one side pulse traveling 400usec
360 Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain: 8mA/idle and 100mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Direct Drive
Bearing Type: Ball Bearing
Gear Type: AGTT Karbonite Gears
Connector Wire Length: 6.29" (160mm)
Dimensions: See Schematics
Weight: 0.29oz (8.5g)
Building on the success of AGTT geared HS-45HB we now add the HS-5045HB to our line up of micro digitals. The all new HS-5045HB Premium Feather servo is quickly going to revolutionize the micro servo market. Most micro servos cut corners to save weight and this makes them not center correctly or fail too soon. The HS-5045HB is loaded with features normally found on much larger standard size premium digital servos. In the HS-5045HB you will find Hitec’s ground breaking, patented AGTT Karbonite geartrain which was designed to allow the gears to slip instead of strip and is supported by a single top ball bearing. They also designed a new patent pending layout for the gears so that the potentiometer is now connected directly to the circuit board. Incorporating the sub-micro size Hitec spline means that all of your servo horns from sub-micro size Hitec servos work with the HS-5045HB. The is the most accurate, high quality sub-micro digital servo we have ever tested!
Detailed Specifications
The HS-5045HB is about the size of a quarter.
A = .392” (9.96mm)
B = .294” (7.48mm)
C = .823” (20.90mm)
E = .193” (4.90mm)
F = .752” (19.09mm)
G = .352” (8.93mm)
H = .604” (15.35mm)
J = 1.323” (33.60mm)
K = .276” (7.00mm)
L = .078” (1.98mm)
M = .944” (23.99mm)
X = .096” (2.43mm)
Use A1 Micro Spline
This servo can be configured to operate 180° by using any of the following servo programmers:
Hitec HFP-25, HPP-21, HPP-21+
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
