|
|
347 oz-in. |
|
0.15 sec/60° |
*Digital servos do not need to be programmed to operate. They work great right out of the box and purchasing a programmer is not necessary.
Programable Features:
- Dead Band Width
- Direction of Rotation
- Speed of Rotation (slower)
- End Points (up to 180 degrees)
- Neutral Points
- Fail Safe On/Off
- Fail Safe Points
- Resolution (default is set at high)
- Overload Protection (default is off)
Gold-Plated Connector
Detailed Specifications
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Amplifier Type: Digital Amplifier & Mosfet Driver
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.18sec/60° at no load
Operating Speed (6.0V): 0.15sec/60° at no load
Stall Torque (4.8V): 278 oz/in. (20kg.cm)
Stall Torque (6.0V): 347 oz/in. (25kg.cm)
Operating Angle: 40 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 3mA/idle and 700mA no load operating
Current Drain (6.0V): 3mA/idle and 840mA no load operating
Stall Current (4.8V): 4000mA
Stall Current (6.0V): 4800mA
Dead Band Width: 2usec
Motor Type: Cored Carbon Brush
Potentiometer Drive: 6-Slider, Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: 1 Resin, 3 Metal Gears
Connector Wire Length: 11.8" (300mm)
Connector Wire Gauge: 22AWG
Connector Wire Strand Count: 60EA
Dimensions: 2.32" x 1.14"x 2.04" (59 x 29 x 52 mm)
Weight: 6.07oz (171.3g)
The HS-5755MG digital servo has it all, metal gears, digital technology, aluminum center case that acts as a heatsink, therma shutdown, and dual ball bearings. This is the top choice for large scale aircraft, especially in the tail. This servo comes with all mounting hardare and an aluminum double arm. We offer the HS-5755MG servo in several configurations, 90° stock rotation, 180° modified rotation, and reverse rotation. Uses the same large 15 tooth spline as the HS-805BB, HS-815BB and the HS-5805MG.
This servo can be configured to operate 180° by using any of the following servo programmers:
Hitec HFP-25, HPP-21, HPP-21+
D1 Heavy Duty Spline
|
|
|||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
|
|
|
||
15 tooth metal spline
Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
