HS-7775MG Servo

Detailed Specifications

Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 4.8-6.0 Volt Peak to Peak Square Wave
Operating Voltage Range: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C (-68F to +140F)
perating Speed (4.8V): 0.12 sec/60° at no load
Operating Speed (6.0V): 0.10 sec/60° at no load
Stall Torque (4.8V): 99.9oz/in. (7.2kg.cm)
Stall Torque (6.0V): 124.9oz/in. (9.0kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Dead Band Width: 2usec
Motor Type: Coreless Carbon Brush
Potentiometer Drive: 6 Slider Indirect Drive
Bearing Type: Dual Ball Bearing MR106
Gear Type: Metal Gears
Connector Wire Length: 7" (178mm)
Dimensions: 1.59" x 0.82"x 1.0" (40.4 x 21 x 25.4mm)
Weight: 1.72oz (49g)

Price:

$89.99

Part:

37775S

Status:

Rotation:

Direction:

Qty:

124 oz-in.

0.10 sec/60°

*Digital servos do not need to be programmed to operate. They work great right out of the box and purchasing a programmer is not necessary.

Programable Features:
- Dead Band Width
- Direction of Rotation
- Speed of Rotation (slower)
- End Points (up to 180 degrees)
- Neutral Points
- Fail Safe On/Off
- Fail Safe Points
- Resolution (default is set at high)
- Overload Protection (default is off)

Metal Output Spline

Gold-Plated Connector

The HS-7775MG is a low profile digital servo. In applications where a standard servo is too deep, this servo will usually work extremely well. Although it is very shallow, it still manages to produce an amazing 124 oz-in. of torque at 6 volts with a lightening fast .10 sec. travel time. All standard Hitec horns and arms will fit since it utilized Hitecs 24 tooth standard spline configuration. We also offer the HS-7775MG set for 180° rotation and reverse rotation.

This servo can be configured to operate 180° by using any of the following servo programmers:
Hitec HFP-25, HPP-21, HPP-21+