|
|
51 oz-in. |
|
0.24 sec/60° |
Control System: +Pulse Width Control 1520usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.24sec/60 degrees at no load
Stall Torque (4.8V): 51 oz/in. (4.5kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
Direction: Counter Clockwise/Pulse Traveling 1520-1900usec
Motor Type: Brush 3-Pole Motor
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: All Metal Gears
Connector Wire Length: 12"
Dimensions: 1.18" x 0.44"x 1.125" (30 x 11 x 29mm)
Weight: .8 oz. (20g)
Detailed Specifications
(USB Interface)
Note: The CIU-2 Programmer is only for use with Futaba Serial Bus Series Servos
Uses a 3F Standard Spline (25T)
Futaba Servo Accessories
Click on the picture for further information.
Servo Screws
Servo Hardware
Servo Extensions
Servo Arms
Futaba Casesets
Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
