|
|
425 oz-in. |
|
0.14 sec/60° |
S9075SB included hardware
(USB Interface)
Note: The CIU-2 Programmer is only for use with Futaba Serial Bus Series Servos
Detailed Specifications
Control System: +Pulse Width Control
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 6.0
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (6.0V): 0.14sec/60 degrees at no load
Stall Torque (6.0V): 425 oz/in. (30.6 kg-cm)
Motor Type: Brush 3-Pole Motor
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearings
Gear Type: Metal
Connector Wire Length: 12"
Dimensions: 1.59” x 0.83” x 1.47” (40.5 x 21 x 37.4mm)
Weight: 2.50 oz. (71g)
Features:
-Compatible with the Futaba S.Bus system
-Equipped with metal gears
-Servo can be easily programmed with the SBC-1 Channel setting tool, S.Bus receiver or PCLink software.
Uses a 3F Standard Spline (25T)
Copyright 1999-2012 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
