S9350 Hi-Torque Steering

Control System: +Pulse Width Control 1520usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.15sec/60 degrees at no load
Operating Speed (6.0V): 0.12sec/60 degrees at no load
Stall Torque (4.8V): 111 oz/in. (8kg.cm)
Stall Torque (6.0V): 139 oz/in. (10kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Counter Clockwise/Pulse Traveling 1520-1900usec
Motor Type: Coreless Motor
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearings
Gear Type: All Metal Gears
Connector Wire Length: 12"
Dimensions: 1.6" x 0.8"x 1.5" (41 x 20 x 38mm)
Weight: 1.4oz. (41g)

Detailed Specifications

S9350 Digital Servo Precautions, -It is best to avoid long leads and Y-harnesses especially with standard grade wires. If problems are encountered, consider using heavy duty wire such as Futaba's Heavy Duty Series or Hobbico's Pro Series ,minimizing lead lengths, and/or removing Y-harnesses. -Current Drain: Futaba S9350 Servo is Specially Designed for High- Torque and High-Speed, Therefore Very High Current Drain Is Normal At Startup.
For Ultimate Performance When Using This Servo Please Review The Following Points.
(1) When Using Systems With the Battery Fail Safe Function it Has a Higher Cut-Off Voltage Setting Which Will Cause Shorter Operation Time.
(2) When Installing the Servo Please Check Pushrod Linkage To Make Sure There Is No Binding in Order To Prevent Excessive Power Consumption and Decrease the Life of the Motor and Battery.

This digital servo cannot be used with the following * AM * transmitters as the servo neutral signal is: 1310us). CONQUEST AM, FG Series (T4FG, T5FGK,T6FG, T6FGK, T7FGK), New Terra- top, T3EGX, T3PGE, T2NL, T2LGX, T2FR, T2PK series. Otherwise they will work fine with current AM systems.