Shop By Product

Ball Bearing Wheel Mount for 595666

  • shown attached to <a href="/tire-with-5-spoked-wheel">5-Spoked Wheel Pneumatic Tire (595666)</a>
1 of 11

Be the first to review this product

In stock
This Product? Share It!


This wheel adaptor is intended to be used with our 5 spoke pneumatic tire/wheel.  This piece is machined to perfectly mate with the interior shape of the molded wheel so that the adaptor and the wheel will turn as one.  The adaptor houses a 1/2" ID ball bearing so that the assembly can be slid onto a fixed shaft and rotate freely on that shaft.  The 1.5" Actobotics hub pattern is machined into the adaptor so that a sprocket or gear can easily be attached to the outside of the adaptor to drive the wheel assembly.  A single wheel adpator can be used and the other side of the wheel can be supported by one of the stock bearings included with the pneumatic tire/wheel or an adaptor on each side can be utilized for a more symmetrical setup.  We recommend running a 1/2" shaft spacer next to the bearing installed into the adaptor in order to provide proper clearance between the bearing and the surface that it's running next to.  



Product Weight 1.65 oz
Material aluminum with stainless steel ball bearing
Hole Pattern 1.50"

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Connect With Us
Shop Secure

As Featured In

Copyright 1999-2018 Robotzone, LLC - All rights reserved. ServoCity® is a registered trademark of Robotzone, LLC.