Easily attach wheels to a precision gearmotor using a 6mm bore clamping or set screw hub with this mount.
The Aluminum Clamping Motor Mount is great for applications where the perfect motor alignment is needed. When used in conjunction with a gearmotor that has an offset shaft, you can index the motor by sliding the motor forward/aft in the mount or rotating it within the mount. Constructed of 6061-T6 aluminum, you can be sure that this mount is not going to budge even in high torque applications. The included clamping screw is a 6-32 x 1/2” zinc-plated socket head screw that uses a 7/64 hex key.
The two tapped mounting holes on the bottom are 6-32 with a 1/4” depth.
Requires a 7/64” Hex Key
This mount is compatible with our 1.50” Hub Pattern parts. The mounting holes on the bottom of the mount are 1.0607” apart.
Click here for more information.
Shown attaching a standard gearmotor to a section of channel.
The 1.0607” spaced mounting holes allow this mount to attach directly to components with the 1.50” hub pattern - such as the
1” bore tube clamp pictured.
DREAM. DESIGN. BUILD. REPEAT.
Weight: 0.50 oz (each)
Copyright 1999-2015 Robotzone, LLC - All rights reserved.
ServoCity® is a registered trademark of Robotzone, LLC.
Huge Selection. Low Prices.