Click on the picture for further information.
Servo Mount Gears
Hub Mount Gears
Plain Bore Gears
32P Aluminum Hub Gears are available with a 1/2” Bore or a 1” Bore.
TECH TIP: When selecting gears based on two fixed axes, pay close attention to the pitch diameter (PD).
The distance between the axes will be equal to (PD1 + PD2)/2.
For example, if you want a set of gears to mount on the Actobotics channel at a distance of 1.5” you could use a 76T, 32P gear (PD=2.375”) with a 20T, 32P gear (PD=0.625).
(2.375” +0.625”)/2 = 1.5”
Copyright 1999-2015 Robotzone, LLC. - All Rights Reserved
ServoCity is a registered trademark of Robotzone, LLC.
Huge Selection. Low Prices.