(1) Servo Plate
(1) Ball Bearing Plate
(1) Plain Servo Shaft
(2) Hub Plates
(12) 6-32 Screws
Weight (no servo): 1.3 oz
Plain Servo Shaft
We are proud to introduce our new patented ServoBlocks! ServoBlocks increase a servo’s load-bearing capabilities by helping to isolate the lateral load from the servo spline and case. The extreme versatility of ServoBlocks allow users to create complex, extremely rigid, structures with ease using standard Hitec servos. Using a clamping hub (not included) on the ½” aluminum servo shaft provides an easy way to adjust the position of the component attached to the ServoBlock. The robust 6061 T-6 aluminum framework acts as a servo exoskeleton, greatly enhancing the mechanical loads the servo can withstand. Our new .770” hub pattern is repeated throughout the framework to allow endless attachment options. Compatible with all standard size Hitec servos with a 24T spline. Kit comes unassembled, servo not included. Patented. Click here to watch a step by step assembly video.
Ball-bearing supported output shaft.
Hitec ServoBlocks Kit
Using a 0.770” clamping hub (not included) on the ½” aluminum servo shaft provides an easy way to adjust the position of the component attached to the ServoBlock.
Be sure to check out our Clamping Hubs which can be used in conjunction with the plain shaft ServoBlocks. Clamping hubs make indexing the servos in complex structures very easy. Simply loosen the pinch bolt and rotate the hub to the desired position and re-tighten!
ServoBlocksTM utilize a
0.770” hub pattern.
ServoBlocksTM work in conjunction with our new aluminum channel.
This product (#637114) was previously SB609SH.
DREAM. DESIGN. BUILD. REPEAT.
Download a .zip file of the individual ServoBlocks parts.
Increase the load-bearing capabilities of your servos!
Copyright 1999-2015 Robotzone, LLC - All rights reserved.
ServoCity® is a registered trademark of Robotzone, LLC.
Huge Selection. Low Prices.