ServoCity announces a new Micro class servo, the HS-65MG. This new servo has long lasting and durable metal gears and is one of Hitec’s most powerful servo in the micro class, with over 30 oz/in of power at 6 volts. The HS-65MG was created for higher performance micro helicopters, electric park flyers, & 1/18 scale cars, and features a top ball-bearing for long life and positive centering.
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.14sec/60° at no load
Operating Speed (6.0V): 0.11sec/60° at no load
Stall Torque (4.8V): 25 oz/in. (1.8kg.cm)
Stall Torque (6.0V): 31 oz/in. (2.2kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
Continuous Rotation Modifiable: No
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 5.3mA/idle and 400mA no load operating
Current Drain (6.0V): 6.6mA/idle and 500mA no load operating
Dead Band Width: 4usec
Motor Type: 3-Pole Neodynium Magnet
Potentiometer Drive: Indirect Drive
Bearing Type: Top Ball Bearing
Gear Type: Metal Gears
Connector Wire Length: 6" (150mm)
Dimensions: 0.92" x 0.45"x 0.94" (23.6 x 11.6 x 24mm)
Weight: .39oz. (11.2g)
This servo can operate 180° when given a pulse signal ranging from 600usec to 2400usec. Since most R/C controllers cannot generate this wide of signal range, you will need to use our servo stretcher for 180° operation.
Uses B1 Mini Spline
Hitec Servo Accessories
Click on the picture for further information.
General Servo Information
Huge Selection. Low Prices.
Copyright 1999-2015 Robotzone, LLC - All rights reserved.
ServoCity® is a registered trademark of Robotzone, LLC.