• Handles over 1,500 oz-in. of torque without slipping
• 6061 T6 Aluminum
• Fits right onto servo spline
• Offered in both Hitec (24T spline) & Futaba (25T spline)
Pictures below show included hardware for the various couplers.
A Servo to Shaft Coupler offers a simple and solid way to attach a shaft in line with the output spline of a servo. Each servo to shaft coupler is machined from 6061 T6 aluminum with a broached Acetyl insert that snugly fits over the servo spline. Once installed onto the servo the coupler is then fastened to the servo using a servo screw (details on servo screw). The shaft can then be slid into place and clamped using the supplied 5-40 socket head screw (requires a 5/64” hex key). Offered in 24T (C1 Hitec) and 25T (3F Futaba) splines. Patented
DREAM. DESIGN. BUILD. REPEAT.
Hitec C1 Standard Spline (24T)
Futaba 3F Standard Spline (25T)
No servo screws included. Stock servo screw supplied with Hitec or Futaba servo should be used.
Coarse thread micro head screw (for plastic gear servo) is included. Will not fit metal gear servo as no machine screw is supplied for this bore size.
Coarse thread micro head screw (for plastic gear servo) is included and a M2.6 x 8mm screw (for metal gear servo) are included.
Huge Selection. Low Prices.
Copyright 1999-2015 Robotzone, LLC - All rights reserved.
ServoCity® is a registered trademark of Robotzone, LLC.