Perfect for robotics, animation, pan & tilt, and just about any project requiring servo power!
(1) Servo Plate
(1) Ball Bearing Plate
(1) Servo Spline Shaft Hub
(2) Hub Plates
(12) 6-32 Screws
Weight (no servo): 1.3 oz
Servo Spline Shaft Hub
We are proud to introduce our new patented ServoBlocks! ServoBlocks increase a servo’s load-bearing capabilities by helping to isolate the lateral load from the servo spline and case. The extreme versatility of ServoBlocks allow users to create complex, extremely rigid, structures with ease using standard Hitec servos. The ½” aluminum hub shaft provides multiple mounting options using 6-32 screws. The robust 6061 T-6 aluminum framework acts as a servo
exoskeleton, greatly enhancing the mechanical loads the servo can withstand. Our new .770” hub pattern is repeated throughout the framework to allow endless attachment options. Compatible with standard size Hitec servos with a 24T spline. Kit comes unassembled, servo not included. Patented.
Ball-bearing supported output shaft.
Hitec ServoBlocks Kit
Shown with a
Tube Clamping Hub (.770”) and 0.5” Hollow Aluminum Tubing
These ServoBlocksTM and our 0.770 - 0.625 hub adaptor are both approved for use in the FIRST® Tech Challenge.
Use this hub adaptor (sold separately) to make ServoBlocksTM compatible with FTC Components!
ServoBlocksTM utilize a
0.770” hub pattern.
ServoBlocksTM work in conjunction with our new aluminum channel.
This product (#637110) was previously SB608SH.
Increase the load-bearing capabilities of your servos!
DREAM. DESIGN. BUILD. REPEAT.
Huge Selection. Low Prices.
Copyright 1999-2015 Robotzone, LLC - All rights reserved.
ServoCity® is a registered trademark of Robotzone, LLC.